
2: Description and Specifications
MatchPort b/g Pro Integration Guide 18
E_LINKLED, E_ACTLED
Current Drive (sink)
ELED
Notes:
Do not connect a pull-down resistor on E_LINKLED and E_ACTLED.
All pins are not 5V-tolerant.
Wireless Specifications
Refer to the following table for the MatchPort b/g Pro’s wireless specifications:
Table 2-5. Wireless Specifications
14 +2.0/- 1.5 dBm 1, 2, 5.5, 11 Mbps
12 +/- 1.5 dBm 6, 9, ≥ 12 Mbps
Antenna Connector RF, U-FL TYPE
HIROSE PN = U_FL-R-SMT-10
1,2,5.5,11,6,9,12,18,24,36,48,54
Mbps
Radio
Number of
Selectable
Subchannels
US 1-11
CA 1-11
JP 1-14
FR 10-13
SP 10-11
DSSS,DBPSK,DQPSK,CCK, OFDM,
16QAM, 64QAM
Security WEP, WPA, WPA2/802.11i, EAP-
TLS, EAP-TTLS, PEAP, LEAP
-88 dBm for 11 Mbps
-85 dBm for 6 Mbps
Technical Specifications
Table 2-6. Specifications
CPU
Lantronix DSTni-FX 32-bit Microprocessor, 166 MHz internal bus, 83
MHz external bus
64 Mbits Flash and 64 Mbits SDRAM
Upgradeable via TFTP, FTP, and the Web
Up to 7 pins if no DTR or DCD is used on serial ports.
Reset Circuit RESETIN# is low active and push-button type. Minimum RESETIN# pulse
width is 2 ms at IIL = -500 µA. Reset is also triggered if 3.3V at pin P1.37
drops below 2.93V typically.
CMOS (Asynchronous) 3.3V - level signals
Speed software selectable and customizable (300 bps to 230400 bps)
7 or 8 data bits, 1-2 Stop bits, Parity: odd, even, none
Comentarios a estos manuales