Max Security Max-G Pro 4 Especificaciones descargar pdf (Pagina 26)

3: Demonstration Kit

MatchPort b/g Pro Integration Guide 26

JP7

pin/Signal

JP7

pin/Signal

Function

b/g Pro

13/CP5

14/DTRB

Jumper 13-14, CP5 drives DTR to RS232 transceiver.

15/CP6 16/DCDB Jumper 15-16, CP6 receives DCD from RS232

transceiver.

Note: CP allocation in the tables above is the most straightforward for this

specific board. However any CP can be assigned to any function. To reflect

actual CP use in the eventual product (in case different), jumpers can be

replaced with short wires to allow interchanging of connections.

Table 3-7. Demo Board JP5 Jumper Configuration

Pin/Signal

Function

1/3V3

2/3V3_UUT

Jumper 1-2, MatchPort module power supply.

Note: Jumper can be replaced with short wire to allow use of a current clamp or <50

milliohm resistor to allow use of voltmeter for current measurements.

If using CPs for any combination of the demo board configurations above, please use the

appropriate CP function selection as shown in Table 3-3 to Table 3-7.

If assigning a CP for any function other than the serial port, remove the jumper for the

associated CP pin from JP7 to avoid conflict with the serial port function.

Table 3-8. Demo Board Configurable Pin Jumper Configurations

Configurable Pin

JP1 Function

JP7,JP8 Function

CP1

LED12

JP7, CON1 DTR

CP2

LED11

JP7, CON1 DCD

CP3

LED10

JP7, CON1 RS485/232 Select

CP4

LED9

JP7, CON1 RS485 Duplex Select

CP5

LED8

JP8, CON2 DTR

CP6

LED7

JP8, CON2 DCD

CP7

LED6

JP8, leave open

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

Comentarios a estos manuales

Sin comentarios

Max Security Max-G Pro 4 Especificaciones Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Max Security Max-G Pro 4